Jenco pH/ORP Controller, Voltage Output, LED Display, 1/8 Din Panel Mount

$435.12

In stock

Overview

SKU

3671N

Overview

Jenco pH/ORP Controller, Voltage Output, LED Display, 1/8 Din Panel Mount

Skip to the end of the images gallery

Skip to the beginning of the images gallery

Overview

1/8 DIN panel mount pH/ORP controller with dual SPDT Hi/Lo relays, manual set points and calibration are via potentiometers. Features a voltage/recorder output and an internal pH/ORP select switch. Display is a large bright red LED. Connectors are a BNC input and spade lug screw type connector block. Meter requires a Pt-100 ATC or a simulation resistor for temperature. Power115/230 VAC.

All solid state design
Low cost
Easy to install
Set points on front panel
Recorder output
0.56 high efficiency red led display
1/8 DIN aluminum case
Set points cover entire span
ATC for pH 0 to 100 °C
Internal pH/ORP select switch
Low power consumption design, reduced internal heating thus increased reliability

Technical Specifications

More Information
Input impedance	1012 ohms
ORP Accuracy	±0.1% F.S. ± 1 digits
ORP Range	-1990 to 1990 mV
ORP Resolution	10 mV
Relay Output	8 A at 115 VAC, 4 A at 230 VAC
Temperature Accuracy	±1 °C ± 1 digit
Temperature Range	0 to 100 °C
Temperature Resolution	1 °C
pH Accuracy	±0.1 pH ± 1 digit
pH Range	0 to 14 pH
pH Resolution	0.1 pH
Weight	690 g
Dead Band	±0.1 pH for each set point
Dimension	96 x 48 x 172 mm
Dual Point on/off Control	pH or ORP with internal select switch
Power source	115 VAC/230 VAC ±15%, 50/60 Hz
Readout	0.56 high efficiency red LED display
Recorder Output (mV)	0 to 1400 mV
Recorder Output (pH)	0.0
Temperature Compensation	Auto 0 to 100 °C

Downloads

Technical Data Sheets

Accessories

No Records Found

Jenco pH/ORP Controller, Voltage Output, LED Display, 1/8 Din Panel Mount

Overview